After Ryan’s mold making workshop a couple of weeks ago, I began to think more about mold making as a way to prototype, given metal 3D printing is a bit cost and time prohibitive given our course coming to an end so soon. I began looking into ways to cast metal at home which my […]
Read more "Silicone Mold Making & Chocolate Cane Handles – Experiment 1"Due to software updates of both Rhino & Grasshopper, the tutorial I found for a Voronoi cylinder didn’t work out perfectly, as hoped. I got almost done to the point where it was time to wrap the Voronoi plane around a cylinder, but due to some coding mismatches, it wasn’t possibly. Luckily, Ryan saved the […]
Read more "Initial 3D Prototype & Voronoi Cylinder Tutorial in Grasshopper w/ Rhino 3D"First we drew a schematic for the pattern of the vest. We then experimented with the materials. This is a shower curtain that we used the industrial heat sealer to seal edges of the plastic. We then filled the compartment with water and sealed the final edge to create a packet of water. This […]
Read more "Mock-up #1: Shower Curtain Vest Video"As 2 of the 3 team members were out this week sick, Kyle was point and taking not only the lead but the full team burden in the workshop session. We wanted to clarify the objective of this assignment, just to make sure we fully understood the end goal. Annet confirmed that we should be […]
Read more "Feedback #2: Meeting w/ Annet"Maker: Phil Meredith
Read more "Pre-Mock-Up Process: Sketches"
design4innov8 